&We often see some wire crafts with appreciation value. When we go to buy wire crafts, it's hard to find what we want. If we know how to make iron wire crafts, can we do it by ourselves? Well, then we can get the wire crafts we want.

I. original data processing of iron wire crafts

First of all, we should prepare the raw materials according to the manufacturing requirements. The types of wire used for making wire jewelry racks include polished smooth wire on the surface of the wire, Xiangsi wire wound by a circle of thin wire around, the smooth wire in the center removed, horse wire with hollow and similar spring, and lace wire with lace around after self processing.

II. Straightening treatment

When these wire materials are introduced from manufacturers, they are mostly in a pile of bending shape. To end the manufacturing of wire jewelry frame, it is necessary to straighten the wire materials first. When straightening the wire, the thing used is a modified bench drill. The drill bit is hook shaped, which is used to fix one end of the wire before horizontal punching. First, pull out the piles of wires. It is suggested that two people work together. One is to loosen the wire reel and the other is to gradually pull out. Determine the required length and tighten one end of the wire to the bench drill. At one end, the wire was clamped firmly by other workers with pliers. Hold the wire with your hand and start the bench drill. In order to achieve the effect of not damaging the wire's resistance but also fully straightening, the forward and reverse replacement rolling is adopted. After admitting that it has been straightened, cut the wire from the end of the bench drill.

III. wire pressing

Next, we need to flatten some wire data, that is, wire pressing. Crimping will be used in some parts of the bending and finishing operations. The binding wire is finished by a special wire press. Firstly, the wire information is gradually put into the binding wheel through the opening. The opening is used to prevent the wire from swinging at will during the wire pressing process, so that the bound wire is even and smooth. With the wheel rolling, another person should timely take the wire through the shackle wheel and stretch it out. During operation, the strength of the two people should cooperate properly to avoid risks. Then, cut the whole wire into small sections as required, which is the wire after wire pressing. The shape of wire bound by different wire data is also different.

IV. manufacturing of horse

Horse silk is a kind of hollow wire material similar to spring, which needs us to process and manufacture by ourselves. Its hollow feature is suitable for making loose leaf of jewelry cabinet. It is still a bench drill that is used to make horse wire. First, fix the smooth wire with larger diameter at the bit part as the core. Put the wire with the smaller diameter through the special thread rolling device and wrap it on the fixed core. Start the bench drill, catch the spinneret and do not roll with it. The fine wire rolls with the drill. Form it in the spinneret and gradually move out of the spinneret and coil it onto the core. The thickness of the rolled horse silk is the same as that of the hole diameter of the silk kneader. In order to make the horse silk uniform and common, attention should be paid to the force and speed of the external movement of the wire rubbing device in operation. Too much force and too fast speed are not conducive to the processing of good horse silk.

Article origin: Jiangmen fried baskethttp://www.jmhylwj.com